#16
|
||||
|
||||
I soldered up a custom wiring harness for my Steel Di2 BreakAway:
One hole drilled up at the DT/HT junction. Unscientifically located (I guessed) below the heat affected zone of the DT/HT TIG weld and above the tube butt transition. Two splices take the place of the 4-port junction such that the only connection is an eTube JC200 2-port junction located at the DT coupler. The splices were done with heat shrink butt connectors and sealed with adhesive heat shrink tubing. They seem pretty water resistant; however I would not take them swimming. By utilizing the BB drain hole and dropout vent, I was able to reduce the frame modifications to a single 3mm drilling near the HT. Here's a crude drawing: Last edited by Look585; 11-11-2019 at 01:04 PM. |
#17
|
||||
|
||||
Quote:
Oh, and I snagged that ti Cross you to which you alerted me. It'll likely replace the BA Outback, in time, with eTap, of course. |
#18
|
|||
|
|||
Quote:
Sent from my Pixel 2 XL using Tapatalk
__________________
Io non posso vivere senza la mia strada e la mia bici -- DP |
|
|