#1
|
|||
|
|||
Saving valve cores
I recently had a slow leak in a tube and figured out that it was coming from the valve core. I took some pliers and tightened it and fixed the problem.
That got me thinking. I usually patch tubes a couple of times but always carry a new tube when on a ride. If I have more than two patches or I can't patch the hole, I toss the tube. But, I have never thought about saving the valve core. Do any of you remove the valve cores to save as spares, or is this just my hoarding tendency coming out? |
#2
|
|||
|
|||
Quote:
|
#3
|
|||
|
|||
I doubt that I will ever stop using tubes nor switch to disk brakes. I'm 53. I can't see the rationale for switching.
|
#4
|
|||
|
|||
Sir, this is a Wendy's.
|
#5
|
|||
|
|||
I save them, but you can buy a whole bunch of valve cores on Amazon or ebay for cheap anyway.
|
#6
|
|||
|
|||
Yes, and I do the same. Still run tubes on my one of my road bikes, so I have an occasional source of cores...
|
#7
|
|||
|
|||
What are you people doing with spare valve cores?
Short answer...you don't need to keep spare ones. If one isn't working correctly, and you really, really need one pull one from a tube you have. You can always put it back. Or, if it's leaking, fix it (like OP did).
__________________
"I used to be with it. Then they changed what it was. Now, what I'm with isn't it, and whats it is weird and scary." -Abe Simpson |
#8
|
|||
|
|||
I started saving valve after I switched to tubless on my mtb since I tend to replace the valve stuck with Orange Seal every 3-4 months, or after a bad sealant replenish job. I have a bag of spare valves bought from Amazon should last me for years. But I still love the happy feeling of not wasting useful resources.
|
#9
|
|||
|
|||
I carry a spare core in my bag and have half a dozen in my tool box.
|
#10
|
||||
|
||||
Switched one out yesterday, I find Continental tubulars, specifically Sonderklasse tubulars have problematic valve cores. The small black valve core seal seems to stick to the apposing seat and not release cleanly. Upon valve core removal the black seal often appears mis aligned on the valve core shaft allowing for a slow leak or complete deflation. Following a few months of daily pump ups, this seems to be a routine occurrence. So, I always harvest from my old tubes and keep spares accessible. Going to try maintaining the cores with a small dose of Silicone spray and observe if this cures the issue.
__________________
Marc Sasso A part of the resin revolution! |
#11
|
|||
|
|||
Most shop mechanics are scavenging valve cores since tubeless has become popular. Trying to clean out valve cores sucks.
__________________
Forgive me for posting dumb stuff. Chris Little Rock, AR |
#12
|
|||
|
|||
Quote:
I recently switched to valves that don’t seem like they will clog so bought a big bag of valve replacements and will be listing all my pretty presta valves such as muc off iridescent! |
|
|