Bearing removal from an Alex wheel

[clyde the point]

The bearing needs to come out in order to remove the freehub assembly from the hub. The non drive side was easy, it had a "lip" available to push from. The drive side has like a 1mm lip that is difficult to contact. I believe the drive side bearing must come out to remove the freehub body, which appears to be similar to Shimano using a big 14mm? allen key. The 14mm key does not fit through the non-drive side of the hub. These are Devox branded rims, Felt's house private label. The Alex # is BRD-50812N
Pics below, welcoming suggestions. Thanks.
[IMG]IMG_0057 by Clyde the Pointer, on Flickr[/IMG]
[IMG]IMG_0058 by Clyde the Pointer, on Flickr[/IMG]
[IMG]IMG_0059 by Clyde the Pointer, on Flickr[/IMG]