#1
|
|||
|
|||
Pegoretti seatpost question
I'm building up a 2015 Pegoretti Marcello. A 31.6 seatpost is too big to slide into the main tube (without undue force). With a 30.9 seatpost, I need to tighten the seatclamp with a lot of force, in order to keep the seatpost from sliding.
I'm worried about bearing down on the seat clamp. Is this an issue? Thanks. EWO
__________________
Did you just call me fat? |
#2
|
|||
|
|||
Have you verified that your 31.6 post truly is 31.6 and not a bit more than that?
Or that the seat tube diameter is ~31.6? According to the link below, the Marcelo should take a 31.6 post. https://www.bikyle.com/PegGeometry.htm#Sizings |
#3
|
|||
|
|||
Re:
Sounds like the frame is intended to take a 31.6mm post. You may have paint, slag, etc. inside the tube reducing the clearance. Take it to a good shop/frame builder and have it reamed out to the correct size.
|
|
|