#1
|
|||
|
|||
DT Swiss - Non Drive side endcap question
I just got a set of wheels that are used, and the end cap on the rear non drive side looks a little scuffed up. I want to replace it and I think i have the right part but want to make sure.
The wheels are Roval Terra C 12x142 TA with XDR freehub body. DT Swiss 370 LN hubs. Would the non drive side just be a standard 12x142 end cap like this: https://www.modernbike.com/dt-swiss-...-cap-rear-hubs Part number: HWA00100S2193C I assume that it doesn't matter what hub body is on the wheel (xdr, 11 sp shimano). Thanks for any assistance! Last edited by emjayel; 09-30-2022 at 07:41 AM. |
#2
|
|||
|
|||
DT swiss will tell you what end cap you need. There is some fine print somewhere on the hub that you need to tell them.
|
#3
|
||||
|
||||
yeah - email them. They're good about this.
They'll want the serial number of the hub. Check Youtube for a video from DT on where to find the number if it's not obvious.
__________________
What about my dynamite? |
#4
|
|||
|
|||
Seems to be the correct part...
at least based on the soemwhat confusing DT parts finder:
https://www.dtswiss.com/en/support/p...support#filter DT 370, j bend, 142mm x 12 axle shows this as the NDS end cap HWA00100S2193C |
#5
|
|||
|
|||
I had a roval wheel with a very confusing part number - and went to my Specialized dealer who knew what to get.
|
|
|