Source for curved washer for campagnolo downtube shifter

[texbike]

I'm happy to just send them to you to test out if you like. If they work, great. If not, just send them back.

Cheers,

Texbike

[oliver1850]

I think the parts Tex has are all friction era stuff, which are about 7 mm smaller in diameter than what you lost. I think they will work though. I dug a similar bolt and washer out and tried it on the bar end shifter. It works if you don't mind the look. As Peter mentioned, the RH bolt is quite a bit longer but the shorter ones will catch enough thread to hold it together.

[jtakeda]

Originally Posted by oliver1850

I think the parts Tex has are all friction era stuff, which are about 7 mm smaller in diameter than what you lost. I think they will work though. I dug a similar bolt and washer out and tried it on the bar end shifter. It works if you don't mind the look. As Peter mentioned, the RH bolt is quite a bit longer but the shorter ones will catch enough thread to hold it together.

Thank you for checking.

Aesthetics are always important but functionality is paramount. I’ll use the texbike parts as a stop gap and find the real deal when someone has a destroyed shifter they’re throwing away

[jtakeda]

Originally Posted by texbike

I'm happy to just send them to you to test out if you like. If they work, great. If not, just send them back.

Cheers,

Texbike

Trying to message you back. Mailbox is full

[texbike]

Originally Posted by jtakeda

Trying to message you back. Mailbox is full

Apologies! Fixed.