Quick release skewer/Thru axel

[cookietom]

How to change from thru axel to quick release skewer?

[jtakeda]

somethin like this
https://www.nashbar.com/problem-solv...a-12mm/p664126

If youre talking about the rear, you cant without having a hub where you can swap out the end caps

[cookietom]

Originally Posted by jtakeda

somethin like this
https://www.nashbar.com/problem-solv...a-12mm/p664126

If youre talking about the rear, you cant without having a hub where you can swap out the end caps

Thanks, it is for front hub. Rear already have quick release. I need 20mm not 12mm.

[jtakeda]

Originally Posted by cookietom

Thanks, it is for front hub. Rear already have quick release. I need 20mm not 12mm.

From my understanding a 20mm thru axle is based on a longer axle standard (longer than 100mm) so the answer is entirely hub dependent and is based on whether your hub manufacturer has an adapter available

[ColonelJLloyd]

Yes, I believe that standard was short-lived and was 20x110, but was not Boost (rotor in same place as 15/12x100).

I have SRAM 900 front hubs that convert to the following with only tool-free end caps:

9x100 QR
12x100
15x100
20x110

In short, we need more info. What hub are you trying to convert, OP?

[cookietom]

Originally Posted by ColonelJLloyd

Yes, I believe that standard was short-lived and was 20x110, but was not Boost (rotor in same place as 15/12x100).

I have SRAM 900 front hubs that convert to the following with only tool-free end caps:

9x100 QR
12x100
15x100
20x110

In short, we need more info. What hub are you trying to convert, OP?

Rocky Mtn.

I found one made in Poland,,it is 20mmx100 mm but it moved a little.