#1
|
|||
|
|||
Campagnolo Bora One front hub question
I have a set and recently went to strip the front hub to clean & re-grease the bearings but can't figure out how to pry the dust cap off. Some online vids seem to show it's plastic and therefore easily pried off with small flat blade screwdriver but mine feels more like metal and there's almost no room to get purchase without marring the dust cap or CF hub shell.
Any ideas what I'm not doing? |
#2
|
||||
|
||||
Quote:
__________________
Chisholm's Custom Wheels Qui Si Parla Campagnolo |
#3
|
|||
|
|||
Yep, that's the ticket, I couldn't figure out how to remove "E". Will give it try today and let you know how it ends up.
BTW, I've read online that some people use specialty grease for the USB bearings while others lightly lube with an oil. Preference? Here in SoCal we never get rain so I'm thinking the bearings shouldn't be too dirty with about 7k miles on them. |
#4
|
||||
|
||||
Quote:
I recommend grease as it acts as a great seal between inside and outside. USB balls are very hard and if get some grit in there you can kill the cone and/or the cup. Any grease.. I use a mix of waterproof boat grease and white lithium BUT for Campag hubs, I use my big tub of white Campag grease..mmmm, even smells good. This video is of the rear hub but if you look at just the left side stuff and discount replacing the cups..the front hub, left side seals and such is the same. https://www.campagnolo.com/US/en/Sup...olo_wheels_hub
__________________
Chisholm's Custom Wheels Qui Si Parla Campagnolo Last edited by oldpotatoe; 10-22-2019 at 09:43 AM. |
#5
|
|||
|
|||
If you are talking about the plastic piece with the same diameter as the hub on the opposite side of the bearing adjust cone, then you should be able to pop it off fairly easy. Bora ones use the same hubs as zondas if i remember correctly and mine came off by using my fingernails.
|
#6
|
|||
|
|||
Thanks Oldpotatoe, it worked like a charm! However after cleaning everything in degreaser (I used Park's bio liquid), lightly oiling with Tri-Flow, re-assembling with the slightest amount of grease they're super loud and notchy.
I was very careful to dry the bearings (exceptionally warm day here) and finished with compressed air. Now that I know the trick to disassembly I'll pull everything apart, re-clean, re-grease and try again. |
#7
|
||||
|
||||
Quote:
__________________
Chisholm's Custom Wheels Qui Si Parla Campagnolo |
#8
|
|||
|
|||
|
|