#16
|
||||
|
||||
See a few threads discussing the topic.
I searched "lengthening steel fork steerer tube" Here's just one. https://forum.bikeradar.com/discussi...mment_18428777 |
#17
|
|||
|
|||
A few years ago I asked about replacing the 1" steerer on a Nobilette fork. Even Nobilette said not to do it. Heating the crown to sweat out the old one could compromise the entire structure. Builders fabricate in a certain order, just get a new fork.
|
#18
|
|||
|
|||
I The fork in question in a low trail with rack and fender mounts as well as built for a Schmidt SL front hub.
It is usable as it is just not much above the HT. I can fit 1 20mm spacer and the stem. I was hoping to use a high stack stem but even with no spacers it still does not reach the min. insertion of the VO high stack. I will more than likely get a stem made at an angle that will put my bars where I need them to be. Thanks Brian |
#19
|
|||
|
|||
Quote:
|
#20
|
|||
|
|||
Quote:
|
#21
|
|||
|
|||
The HT is 150mm now and at my age and back issues I do not like the have a saddle to bar drop of more than 5cm.
I am in contact with Rich Adams to get a custom stem made at the angle and length I am looking for. |
#22
|
||||
|
||||
Quote:
dave |
|
|