2011 Serotta Ready Custom Geometry

[paredown]

In the interests of completeness, I thought I would put this up before it disappears off the various former dealers' websites:

[Plum Hill]

I’m curious if anyone with a 2011 has compared their frame to this chart.
I have two HSGs, one carbon and one steel, both 57 Performance geometry (177mm head tubes).
The chart has Reach of 36.3 and Stack of 63.7.
I measured the carbon and it’s Reach is 38 +- a few millimeters and the Stack is 60.3 mm. The steel varies a few millimeters but it had S&S couplers installed.
How could they put out a chart that’s off by this much?

[Dave]

You really think that you can take reach and stack measurements at home to a few millimeters accuracy?

Even if you could, a few millimeters is trivial.

[Road Fan]

Originally Posted by Dave

You really think that you can take reach and stack measurements at home to a few millimeters accuracy?

Even if you could, a few millimeters is trivial.

Out of curiousity, why can't readers here take good stack and reach measurements, within, maybe +/- 3 mm? Why would the room in which I measure make any difference?

[Plum Hill]

Originally Posted by Dave

You really think that you can take reach and stack measurements at home to a few millimeters accuracy?

Even if you could, a few millimeters is trivial.

Yes. A steel straightedge and my normal place of measure - on the nuts.
A few millimeters is trivial. A couple of centimeters aren’t.