Need measurements for wheel build, Easton R4 hubs

[Flinch]

Got front and rear R4 hubs on existing wheels, and want to relace them to tubeless rims. While I can get crude measurements, I don't want to take the wheels apart to get accurate measurements if I can find the data on-line. Yeh I can email Easton, but what fun is that when I have all you experts?

Front: Radial laced 100mm OLD, rim brake, 24 hole
Rear: Drive side cross 2, ND side radial laced, 130mm OLD, rim brake, 28 hole

I probably can get the front data, but being radial laced the measurements are critical. Data I need are flange spoke hole spacing diameters, offsets for flanges left/right (DL, WL, DR, WR), hub length.

Thanks y'all

[rowebr]

I'm confused by your question...It sounds like you want to build new wheels using the existing hubs laced to new rims that are different than the old rims, is that right? So of course that requires measuring hubs and rim ERD to figure out the lengths for new spokes. So why not just take the plunge and un-lace the old wheels??

[Flinch]

Originally Posted by rowebr

I'm confused by your question...It sounds like you want to build new wheels using the existing hubs laced to new rims that are different than the old rims, is that right? So of course that requires measuring hubs and rim ERD to figure out the lengths for new spokes. So why not just take the plunge and un-lace the old wheels??

'Cause I'm creatively lazy. I need to know the hub dimensions very-preferably without taking the wheels apart. Then I can order rims/spokes (doing my calculation thing beforehand).

Last option, if no one has the hub data, I do it the old fashioned way.

[.RJ]

Originally Posted by Flinch

Got front and rear R4 hubs on existing wheels

You will be better served throwing those hubs into the trash can.