|
|
|
|
#1
09-20-2019, 10:57 PM
|
|||
|
|||
|
protecting rear carbon dropout from wearing out, a sandy washer?
I recently noticed that my bike's rear-wheel contact surface is digging into my bike's rear dropout pretty hard. The dropout surface is full carbon. Is there some type of friction-ish washer I can put in-between them to save my frame's dropout from wearing out? if not what are the other ways to prevent this?
Last edited by zmalwo; 09-20-2019 at 11:27 PM. 
|
 |
|
|
Linear Mode
