Know the rules The Paceline Forum Builder's Spotlight


Go Back   The Paceline Forum > General Discussion

Reply
 
Thread Tools Display Modes
  #16  
Old 07-15-2024, 08:50 AM
Alistair Alistair is offline
Senior Member
 
Join Date: Apr 2011
Posts: 2,060
Until the QC and price for TPU tubes settles down a bit, I'm sticking to cheap butyl in my road bike and tubeless on the gravel and off-road bikes. I have some TPU spares for the mountain bikes, because weight/size, but can't imagine relying on them long-term given the horror stories I've seen here and elsewhere.
Reply With Quote
  #17  
Old 07-15-2024, 05:57 PM
mcteague's Avatar
mcteague mcteague is offline
Senior Member
 
Join Date: Oct 2005
Location: Maryland, USA
Posts: 3,242
Quote:
Originally Posted by johnniecakes View Post
This is my solution. Life is to short to mess with fixing tubes
I’m leaning this direction as well. Seems wasteful but I get the Cyclami tubes via Ali Express at around $4 a tube so not too concerned. Just was curious how others were dealing with it. If I paid $20-30 each, like the major players charge, I may think differently.

Tim
Reply With Quote
  #18  
Old 07-16-2024, 08:00 AM
Derosid Derosid is offline
Member
 
Join Date: May 2024
Posts: 90
I am also leaning towards the “toss it don’t fix it” camp. I switched to TPU tubes about 6 months ago and love them. Light, they hold air well, and I haven’t gotten a flat yet. I don’t mind replacing the tubes if the flats remain so rare for me.

Perceived quality may come down to manufacturers. I tried some of the cheap ones from China, but then stumbled upon TPUBiketubes which seem to be much higher quality and easier to maintain. So far I have no regrets about leaving butyl (heavy) or latex (puncture-prone, rapid air loss).
Reply With Quote
  #19  
Old 07-16-2024, 08:21 AM
ploop098 ploop098 is offline
Registered User
 
Join Date: Oct 2023
Posts: 11
From what I’ve gathered online any good flexible plastic glue will work pretty well for sealing TPU punctures using a TPU patch. Theres a few Loctite plastic glues that look promising. Some people cut up a TPU tube to make patches too.
Reply With Quote
  #20  
Old 07-16-2024, 08:58 AM
jadmt jadmt is offline
Senior Member
 
Join Date: Apr 2022
Posts: 847
I have not had any issues patching my Aerothan tpu tubes. I have one tube that is on it's 3rd tire ~6000 miles without issues. the hole was fairly large, I just cleaned the area really well with an alcohol patch and held the tube firmly over my saddle and put plenty of pressure on the patch using my bump to roll over the patch..I used a schwalbe glueless patch. I have patched others with Park glueless patches with the same success. I think the secret is to clean the area really well and use something hard to roll over the patch while the tube is stretched on a firm surfaces. my SIlica tattico pump and Brooks C17works great.
Reply With Quote
  #21  
Old 07-16-2024, 10:06 AM
MikeD MikeD is offline
Senior Member
 
Join Date: Jan 2015
Posts: 3,112
Quote:
Originally Posted by Alistair View Post
Until the QC and price for TPU tubes settles down a bit, I'm sticking to cheap butyl in my road bike and tubeless on the gravel and off-road bikes. I have some TPU spares for the mountain bikes, because weight/size, but can't imagine relying on them long-term given the horror stories I've seen here and elsewhere.
Are all TPU tubes the same quality? Certainly there are expensive ones and cheap ones. I would imagine that the expensive ones are better quality, but have no proof of this.
Reply With Quote
  #22  
Old 07-16-2024, 10:13 AM
jadmt jadmt is offline
Senior Member
 
Join Date: Apr 2022
Posts: 847
Quote:
Originally Posted by MikeD View Post
Are all TPU tubes the same quality? Certainly there are expensive ones and cheap ones. I would imagine that the expensive ones are better quality, but have no proof of this.
schwalbe aerothans are great quality, not cheap tho.only issue is the valve cores tend to not be tight enough. I have learned to put a dab of super glue on the threads and that has fixed the problem of the cores coming loosen with certain air pumps.
Reply With Quote
  #23  
Old 09-06-2024, 07:19 PM
jadmt jadmt is offline
Senior Member
 
Join Date: Apr 2022
Posts: 847
well crap I hate it when this happens....not sure what I hit but sounded like a gun shot. clean cut all the way through the tire. I won't try saving the tube

the one patch has around 7000 miles on it.
Attached Images
File Type: jpg IMG_7247.jpg (80.1 KB, 167 views)
File Type: jpg IMG_7248.jpg (80.4 KB, 166 views)
File Type: jpg IMG_7250.jpg (65.2 KB, 169 views)
File Type: jpg IMG_7249.jpg (60.6 KB, 167 views)
Reply With Quote
  #24  
Old 09-06-2024, 07:40 PM
AngryScientist's Avatar
AngryScientist AngryScientist is offline
Administrator
 
Join Date: Mar 2010
Location: northeast NJ
Posts: 34,051
Wow that looks like a pretty tough tire casing too. Must have run over something pretty rigid and sharp to do that.
Reply With Quote
  #25  
Old 09-06-2024, 08:30 PM
jadmt jadmt is offline
Senior Member
 
Join Date: Apr 2022
Posts: 847
Quote:
Originally Posted by AngryScientist View Post
Wow that looks like a pretty tough tire casing too. Must have run over something pretty rigid and sharp to do that.
I went back and found the culprits some ass threw some razor blades in the bike lane...I am guessing the front tire went over one and kicked it up just as the rear was passing over it....at the time I did not see anything but it was also over 90F so I was sweating buckets and just went back to see if I could figure out what cut the gravel king so clean....and deep.
Attached Images
File Type: jpg IMG_7251.jpg (123.2 KB, 146 views)
Reply With Quote
  #26  
Old 09-06-2024, 08:36 PM
donevwil's Avatar
donevwil donevwil is offline
Senior Member
 
Join Date: Jan 2013
Location: Petaluma, CA
Posts: 5,090
How did you make it home, a super boot?

My wife had a similar thing happen years ago on her commute home, nails strewn across the bike path. One nail went through the tire, tube and rim, that was an expensive flat. She called me to pick her up, of course.
Reply With Quote
  #27  
Old 09-06-2024, 08:41 PM
jadmt jadmt is offline
Senior Member
 
Join Date: Apr 2022
Posts: 847
Quote:
Originally Posted by donevwil View Post
How did you make it home, a super boot?

My wife had a similar thing happen years ago on her commute home, nails strewn across the bike path. One nail went through the tire, tube and rim, that was an expensive flat. She called me to pick her up, of course.
luckily I was finish up and only had 1/2mile to go so just walked...bike shoes don't make good walking shoes but was able to walk mostly on dirt/grass.
Reply With Quote
  #28  
Old 09-06-2024, 09:17 PM
Unovis Unovis is offline
Member
 
Join Date: Oct 2019
Location: Olympic Peninsula, WA USA.
Posts: 37
I've had terrible luck with trying to upgrade my tubes... Tried Wheelscience tpu tubes and they lasted no time at all. Got a flat, patched it, and the next day it starts leaking from the plastic valve. Replaced it with a Vittoria latex tube and it came unglued at the stem after two weeks- luckily they replaced it under warranty.
Currently waiting to see what happens next. I'll just replace them with the butyl tubes I originally had.
Reply With Quote
  #29  
Old 09-06-2024, 09:21 PM
AngryScientist's Avatar
AngryScientist AngryScientist is offline
Administrator
 
Join Date: Mar 2010
Location: northeast NJ
Posts: 34,051
Quote:
Originally Posted by jadmt View Post
I went back and found the culprits some ass threw some razor blades in the bike lane...I am guessing the front tire went over one and kicked it up just as the rear was passing over it....at the time I did not see anything but it was also over 90F so I was sweating buckets and just went back to see if I could figure out what cut the gravel king so clean....and deep.
Quote:
Originally Posted by donevwil View Post
How did you make it home, a super boot?

My wife had a similar thing happen years ago on her commute home, nails strewn across the bike path. One nail went through the tire, tube and rim, that was an expensive flat. She called me to pick her up, of course.
Man that’s terrible. What kind of sick jerk gets their jollies from throwing crap like that in a bike lane.
Reply With Quote
  #30  
Old 09-07-2024, 07:12 AM
JMT3 JMT3 is offline
Senior Member
 
Join Date: Sep 2022
Location: Urbana, Illinois
Posts: 395
Quote:
Originally Posted by AngryScientist View Post
Man that’s terrible. What kind of sick jerk gets their jollies from throwing crap like that in a bike lane.
The kind of jerk that throws a beer can at you when he rides by in his pick up truck. Has happened to me.
__________________
A bad day on the bike is better than a good day at work!
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:40 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.