Know the rules The Paceline Forum Builder's Spotlight


Go Back   The Paceline Forum > General Discussion

Reply
 
Thread Tools Display Modes
  #1  
Old Yesterday, 06:50 PM
novacyclist's Avatar
novacyclist novacyclist is offline
Member
 
Join Date: Aug 2024
Location: Fairfax, VA
Posts: 72
Polar H10 Battery Question

Anyone that uses the Polar H10 HRM strap get a battery reading (from the Polar app) of 100% even though it is clear it's not even close to being 100%? I've had the original battery for months (maybe 3/4 months?) and I'm starting to get inconsistencies. But when I connect it to the app it says 100%. Any thoughts?
Reply With Quote
  #2  
Old Yesterday, 07:00 PM
herb5998 herb5998 is offline
Senior Member
 
Join Date: Oct 2013
Location: Montreal, QC
Posts: 1,858
Been using an H10 after years of Wahoo warranty replacements. Just replaced my battery after over a year of use, to include indoor training with it.
Reply With Quote
  #3  
Old Yesterday, 07:34 PM
novacyclist's Avatar
novacyclist novacyclist is offline
Member
 
Join Date: Aug 2024
Location: Fairfax, VA
Posts: 72
Yes, I agree. Came from Wahoo but my question is very specific.
Reply With Quote
  #4  
Old Yesterday, 09:12 PM
caneye caneye is offline
Senior Member
 
Join Date: Jun 2020
Posts: 225
Do you remove the H10 pod from the strap after each use?
That should give you longer than the 3-4 months battery life.

I don't pay particular attention to the absolute percentage of battery capacity. Not sure how accurate it is.

Have you checked the app after a few mins of use?
I won't be surprised if it displays 100% in the beginning, then drop off to 50% or less very quickly.

Usually I'll just keep using it until the signal is intermittent (in my case, between 6-8mths), check the App (just to be sure) then swop the battery.
Reply With Quote
  #5  
Old Yesterday, 09:57 PM
djg21 djg21 is offline
Senior Member
 
Join Date: Mar 2004
Location: Saratoga, NY
Posts: 5,464
Quote:
Originally Posted by novacyclist View Post
Anyone that uses the Polar H10 HRM strap get a battery reading (from the Polar app) of 100% even though it is clear it's not even close to being 100%? I've had the original battery for months (maybe 3/4 months?) and I'm starting to get inconsistencies. But when I connect it to the app it says 100%. Any thoughts?
I change the battery when I get a warning on my Garmin Edge that the battery is low. I have two straps that I alternate and rinse well after every use while showering. I take the sensor off the strap after every use. I rarely have to change the battery. I also regularly connect to both my Garmin Edge and my PC (Zwift and Trainer Road) simultaneously. What are you using for to receive and display your HR? Bluetooth or Ant+?
Reply With Quote
  #6  
Old Today, 08:10 AM
novacyclist's Avatar
novacyclist novacyclist is offline
Member
 
Join Date: Aug 2024
Location: Fairfax, VA
Posts: 72
Quote:
Originally Posted by caneye View Post
Do you remove the H10 pod from the strap after each use?
That should give you longer than the 3-4 months battery life.

I don't pay particular attention to the absolute percentage of battery capacity. Not sure how accurate it is.

Have you checked the app after a few mins of use?
I won't be surprised if it displays 100% in the beginning, then drop off to 50% or less very quickly.


Usually I'll just keep using it until the signal is intermittent (in my case, between 6-8mths), check the App (just to be sure) then swop the battery.
Thank you. I think the statement above (in bold) is what I was looking for. I never give it time to settle in.

Just to clarify, I'm not necessarily saying the battery is low and I took take the pod off. I just want to check what the status is. I have it hooked up to my Wahoo and I believe it gives a battery low signal but I'm not there yet.

Thanks everyone!
Reply With Quote
  #7  
Old Today, 10:20 AM
deluz deluz is offline
Senior Member
 
Join Date: Nov 2021
Location: Encinitas, CA
Posts: 2,009
One problem I have with my H10 when using my Garmin 130 Plus is I get a constant low battery warning when connected by Bluetooth. I don't get it when connected by ANT+. I think is a bug in the Garmin as I also get the same thing with cadence sensor. Recently I did get low battery alert connected by ANT+ so I changed the battery and it went away. I measured the battery with a DVM and it read 3.0V so it still seemed good, but it seems these batteries need to be measured under load to get a true reading of their state.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:39 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.