DT Swiss QR hub endcaps - 130-->135 OLD?..

[Pastashop]

Question: are there endcaps for DT Swiss rear hubs that'll take a 130 mm O.L.D. wheel to a 135 mm O.L.D. (this is all for quick release axles)?

TIA!

[tristan]

Only the left endcap needs to change. This is the model for almost all DT hubs
https://www.wheelworks.co.nz/shop-2/...r-center-lock/

[oldpotatoe]

Originally Posted by Pastashop

Question: are there endcaps for DT Swiss rear hubs that'll take a 130 mm O.L.D. wheel to a 135 mm O.L.D. (this is all for quick release axles)?

TIA!

Disc brake or rim brake? I 'think' you need both tho...

Dave at DT will know.

info.us@dtswiss.com

[.RJ]

Yes, you can get end caps for 130, 135, 142 and HG, HG 11, and XD drivers.

If you know what you need I may have it in my parts bin.

[macaroon]

I suspect you'll need to re-dish the wheel.

[slowpoke]

Originally Posted by .RJ

Yes, you can get end caps for 130, 135, 142 and HG, HG 11, and XD drivers.

If you know what you need I may have it in my parts bin.

RJ, would you happen to have the HWGXXX0006383S kit? 135mm straight pull road 11.

[tristan]

Originally Posted by oldpotatoe

Disc brake or rim brake? I 'think' you need both tho...

Dave at DT will know.

info.us@dtswiss.com

Only the left endcap needs to be replaced to widen from 130 to 135mm

The code I linked is for every model 130mm DT hub that uses a 15*28*7mm non driveside bearing which is basically all hubs which weren't from that generation with a few exceptions for prebuilt wheels

[oldpotatoe]

Originally Posted by tristan

Only the left endcap needs to be replaced to widen from 130 to 135mm

Yes, confirmed with DT in Grand Junction..I just couldn't remember But yes, you are correct, just the LH end cap. And of course, if in a wheel..need to re-dish, pull rim to left, a good thing.

[ickymon]

DT Swiss customer service is excellent when reaching out for information. I've always had a response from them usually in a day. DT SWISS 4'evs!!!