#1
|
|||
|
|||
what adhesive recommended for wahoo sensors?
I have a couple of cadence sensors and I could not get the case to snap off to replace the batteries without removing the sensors and wearing out the perfectly shaped oval adhesive strips wahoo provides. I am embarrassed to admit that double-sided tape does not work. What should I look for on amazon for some stronger/thicker adhesive tape? What does the paceline recommend?
|
#2
|
|||
|
|||
you could use heat shrink or electrical tape to reattach the cadence sensor
|
#3
|
|||
|
|||
You might try 3M trim adhesive. It's sort of an industrial-strength rubber cement used to attach auto floor carpet and stuff. It's designed to be removable (like rubber cement it peels off) and doesn't mark/dissolve/damage paint or clear.
We used to use it to mount sew-up tires. I always keep a tube around for whatever comes up around the house. |
#4
|
||||
|
||||
Tape like this two sided clear works. I forget the exact brand we have at work
https://www.amazon.com/Double-Sided-...KZK1TU7TG&th=1 |
#5
|
|||
|
|||
3m vhb
3M VHB
Should be available at auto parts stores and your local DIY |
#6
|
|||
|
|||
This.
|
#7
|
|||
|
|||
A two sided tape is the best option, sticks well, doesn't leave a permanent residue. Just clean both surfaces thoroughly before installation.
|
#8
|
|||
|
|||
Thank you all!
|
#9
|
||||
|
||||
I put my wahoo cadence sensor on my shoe. Works great when you ride different bikes. I use the rubber thingie.
https://www.wahoofitness.com/media/c...ence_mount.jpg Last edited by Old School; 08-25-2024 at 10:24 PM. |
|
|