Know the rules The Paceline Forum Builder's Spotlight


Go Back   The Paceline Forum > General Discussion

Reply
 
Thread Tools Display Modes
  #1  
Old Yesterday, 09:16 AM
Robbos Robbos is offline
Senior Member
 
Join Date: Dec 2010
Posts: 569
Clamping down- bad mix of post and saddle?

I've just installed this Specialized Power Expert with ti rails on my vintage USE seatpost. Anyone think there's an issue with clamping forces on hollow ti rails? Bonus points for those with actual experience with this set-up/issue
Thanks!
PS- Specialized says I should size down to the 143, but this 155 feels mighty comfy, cannot wait until it's warmer for me to test it out!
Attached Images
File Type: jpg Screenshot 2024-11-13 09.12.53.jpg (27.2 KB, 149 views)
Reply With Quote
  #2  
Old Yesterday, 10:27 AM
pdonk pdonk is offline
Senior Member
 
Join Date: Jan 2004
Location: 416
Posts: 3,100
Not the exact same setup, but with a similar design (vintage syncros seatpost) and ti rails (turbomatic 2 with ti rails, another saddle with ti rails I can't remember), I had rails crack due to the bottom cradle creating notches in the rails.

This was before the use of torque wrenches was common, and I likely tightened the clamps down too tight. I would tighten the bolts as loose as possible, but tight enough to keep things in place. That is a big advantage to this design, things only need to be tight enough to offset the force from the other bolt.
Reply With Quote
  #3  
Old Yesterday, 10:46 AM
.RJ .RJ is offline
Senior Member
 
Join Date: Jul 2012
Location: NoVa
Posts: 3,861
I would be worried about all the hard edges on that clamp
Reply With Quote
  #4  
Old Yesterday, 12:02 PM
osbk67 osbk67 is offline
Senior Member
 
Join Date: Aug 2018
Posts: 754
I’ve used a PMP Italian seat post with a very similar lower cage together with a Selle Italia Flite Max with titanium rails (I think they’re hollow, but not certain) off and on over about eight years and perhaps 12000-15000km in total.

No issues to date. I’m c. 83kg. All road usage.
Reply With Quote
  #5  
Old Yesterday, 02:48 PM
dddd dddd is offline
Senior Member
 
Join Date: May 2016
Posts: 2,295
I had constant slipping issues with my old USE seatpost using a ti-railed saddle.

The bending forces on the rails also meant that the saddle top angle changed a lot as I tightened the tiny clamping screw, making saddle leveling with titanium saddle rails a nightmare.

I'm assuming that current USE seatposts use a more-evolved saddle clamping design than mine from 2008 or so. Mine is very different than yours, having two lower cradle pieces that get squeezed together F/R to achieve tightening. The even older ones with two super-tiny screws going through the lower cradles are even harder to adjust and the screw heads tend to round out. But I think yours is yet quite a bit older!

Last edited by dddd; Yesterday at 02:54 PM.
Reply With Quote
  #6  
Old Today, 07:22 AM
Robbos Robbos is offline
Senior Member
 
Join Date: Dec 2010
Posts: 569
Quote:
Originally Posted by dddd View Post
I had constant slipping issues with my old USE seatpost using a ti-railed saddle.

The bending forces on the rails also meant that the saddle top angle changed a lot as I tightened the tiny clamping screw, making saddle leveling with titanium saddle rails a nightmare.

I'm assuming that current USE seatposts use a more-evolved saddle clamping design than mine from 2008 or so. Mine is very different than yours, having two lower cradle pieces that get squeezed together F/R to achieve tightening. The even older ones with two super-tiny screws going through the lower cradles are even harder to adjust and the screw heads tend to round out. But I think yours is yet quite a bit older!
I think you are talking about the USE Alien seatpost clamp. They're notoriously awful, I've one on a USE seatpost and it does not work well at all. Disappointing from USE as I think most of their stuff is really nice. My suspension post from them is much older and still works great, and their new suspension stem looks great. Yes, mine is super old, probably mid to late nineties. There are newer, better posts out there but it's light and simple!
Attached Images
File Type: jpg Screenshot 2024-11-14 07.22.20.jpg (23.0 KB, 38 views)
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:08 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.