Know the rules The Paceline Forum Builder's Spotlight


Go Back   The Paceline Forum > General Discussion

Reply
 
Thread Tools Display Modes
  #1  
Old 10-24-2024, 08:51 AM
C40_guy's Avatar
C40_guy C40_guy is offline
Senior Member
 
Join Date: Aug 2008
Location: New England
Posts: 6,580
On Topic: I'm an idiot

Swapped rear wheels on my Ekar-equipped Watia.

New wheelset has a 42, old one has a 40.

Something seemed off, like I need a longer chain. Hmm...

Ordered chain.

Put original wheelset back on, went for a ride.

Shifting sucked. Awful. Got like three gears with lots of rowing back and forth.

Ready to give up on 13 speed, 1X Ekar.

Then watched this installation/setup video.

Lockout button? *** is a lockout button? My Nuovo Record rear derailleur didn't have a lockout button...

Yea, the RD was in lockout mode. Not sure how that happened. Unlocked it.

Won't have time to validate resolution for a couple of days...but....


edit: Also questioning whether I actually need a longer chain! (Yea, maybe in lockout mode... )
__________________
Colnagi
Mootsies
Sampson
HotTubes
LiteSpeeds
SpeshFat

Last edited by C40_guy; 10-24-2024 at 09:49 AM.
Reply With Quote
  #2  
Old 10-24-2024, 09:12 AM
benb benb is offline
Senior Member
 
Join Date: Apr 2007
Location: Eastern MA
Posts: 10,582
I'm an idiot too.

Was going to start a thread yesterday.

I rode my flat pedal bike to work yesterday. When I went to put air in the rear tire I gashed my hand open barely brushing the pins on my drive side pedal when I pulled the pump off. Bad enough I had to put a band aid on it and then by the time I rode to work I needed to replace the band aid.

Last night I filed some of the pins. They are almost too sharp and grippy anyway. But they were quite hard to dull.
Reply With Quote
  #3  
Old 10-24-2024, 11:21 AM
coreyaugustus coreyaugustus is offline
Senior Member
 
Join Date: Sep 2018
Location: NoVA
Posts: 441
Quote:
Originally Posted by benb View Post
I gashed my hand open barely brushing the pins on my drive side pedal when I pulled the pump off. Bad enough I had to put a band aid on it and then by the time I rode to work I needed to replace the band aid.
OMG this. I refuse to use them. I’ll constantly be cutting my shins when not actually riding.
__________________
insta: @coreyabennett
Reply With Quote
  #4  
Old 10-24-2024, 11:49 AM
duff_duffy duff_duffy is offline
Senior Member
 
Join Date: Jan 2017
Location: southern NJ
Posts: 2,874
Here is my idiot move of the week. Pulled tire off in the house yesterday and did not realize sealant was in the tire as I walked it to the trash can. Nice trail of sealant showing my walk to the trash can. Wife not happy
Reply With Quote
  #5  
Old 10-24-2024, 11:52 AM
Spaghetti Legs Spaghetti Legs is offline
Senior Member
 
Join Date: Aug 2017
Location: C-Ville, VA
Posts: 3,198
OK, so what are we locking out with said button?
Reply With Quote
  #6  
Old 10-24-2024, 11:57 AM
deluz deluz is offline
Senior Member
 
Join Date: Nov 2021
Location: Encinitas, CA
Posts: 1,993
Whenever I install a chain I always get it on the wrong side going through the pulleys so it rubs against the tab on cage. Last time I thought I checked when installing but still got it wrong.
Reply With Quote
  #7  
Old 10-24-2024, 11:57 AM
.RJ .RJ is offline
Senior Member
 
Join Date: Jul 2012
Location: NoVa
Posts: 3,816
Quote:
Originally Posted by Spaghetti Legs View Post
OK, so what are we locking out with said button?
I'm guessing its either disabling the clutch, or locking the cage in a forward position to make removing the rear wheel easier. With a 1x clutched RD it can be a bit of a pain to get the wheel in otherwise.

BenB, for commuting check out the shimano flat pedals, they have a nice rubber pad on them instead of pins and work great for casual riding.
Reply With Quote
  #8  
Old 10-24-2024, 04:45 PM
cgolvin's Avatar
cgolvin cgolvin is offline
#RYFB
 
Join Date: Nov 2016
Location: The Boss Basin
Posts: 5,573
Quote:
Originally Posted by .RJ View Post
I'm guessing its either disabling the clutch, or locking the cage in a forward position to make removing the rear wheel easier.
Yes to both of these, though I'd say the latter is an effect of the former.

When the Rapha rental fleet was made up of Open bikes with Ekar, people would often have terrible shifting … because someone had pulled the rear wheel and neglected to push the button in.

@C40_guy, remember there's a difference between ignorance and stupidity, though of course it's possible for both to obtain simultaneously.
__________________
Gios Peg Bixxis
Reply With Quote
  #9  
Old 10-24-2024, 10:35 PM
C40_guy's Avatar
C40_guy C40_guy is offline
Senior Member
 
Join Date: Aug 2008
Location: New England
Posts: 6,580
Quote:
Originally Posted by Spaghetti Legs View Post
OK, so what are we locking out with said button?
God shifting seems to have been locked out.
__________________
Colnagi
Mootsies
Sampson
HotTubes
LiteSpeeds
SpeshFat
Reply With Quote
  #10  
Old 10-24-2024, 11:59 PM
bigbill bigbill is offline
Senior Member
 
Join Date: Feb 2006
Location: Hackberry, AZ
Posts: 4,010
I bought a used set of campy Neutrons that came with some 23mm Gatorskin wire bead tires. I will bow in submission to whoever got those on in the first place, but I wanted them off. I started by using tire levers and after a few close calls on the razor sharp bladed spokes, I started thinking about what I'd say in the ER while holding my severed fingers in my good hand. I got out my heavy gage wire cutters, the ones I use on 4/0 wire, and cut the tires into pieces until I could pry up the wire beads and cut them. Dodged a bullet there.
Reply With Quote
  #11  
Old Yesterday, 06:17 AM
JMT3 JMT3 is offline
Senior Member
 
Join Date: Sep 2022
Location: Urbana, Illinois
Posts: 393
I by no means am bashing disc brakes and wireless shifting. I do love it and do have it on several bikes. With that said, the bicycle used to be a simple machine and the advances have brought on an additional and many new issues to be solved when they occur and while a pleasure to ride can raise our anxiety level at times.
__________________
A bad day on the bike is better than a good day at work!
Reply With Quote
  #12  
Old 10-24-2024, 09:22 AM
reuben's Avatar
reuben reuben is offline
Senior Member
 
Join Date: Jun 2020
Location: The Land of Pleasant Living
Posts: 5,343
If I may, allow me to shake my fist at your cloud.

It's not you, but the relentless addition of unneeded features!!!

Well, OK, maybe it's a bit of you as well.
__________________
It's not an adventure until something goes wrong. - Yvon C.
Reply With Quote
  #13  
Old 10-24-2024, 09:41 AM
bil bil is offline
Senior Member
 
Join Date: Nov 2019
Location: British Columbia, Canada
Posts: 538
This thread has a lot of potential to grow into a multi-page one...

Last edited by bil; 10-24-2024 at 09:44 AM.
Reply With Quote
  #14  
Old 10-24-2024, 09:48 AM
benb benb is offline
Senior Member
 
Join Date: Apr 2007
Location: Eastern MA
Posts: 10,582
Quote:
Originally Posted by bil View Post
This thread has a lot of potential to grow into a multi-page one...
There's always a way to make yourself an idiot for a day when you get involved with a bike.

But at least less so than a car or a house or a boat.
Reply With Quote
  #15  
Old 10-24-2024, 10:52 AM
Mark McM Mark McM is offline
Senior Member
 
Join Date: Jun 2006
Posts: 12,627
Quote:
Originally Posted by benb View Post
There's always a way to make yourself an idiot for a day when you get involved with a bike.

But at least less so than a car or a house or a boat.
Unless the bike is on the roof of your car when you pull into the garage at your house.
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:19 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.