Quote:
Originally Posted by Mark McM
How closely the logo lines up with the hole depends on where the hub manufacturer puts the logo relative to the spoke holes in the flange.
|
You gave the relation in your previous post, which I appreciate. The position of the logo is uniformly distributed and can be fairly far off on a 32 hole rim, much less on something with fewer spokes. My last hope hub was near the maximum misalignment possible, which drives me crazy. It so close to halfway in between the two spoke locations that I even tried it with the key spoke over one to verify I had it right.
I insist that well built wheels have the logo lined up 180 degrees away from the valve hole, but that's not the way someone arbitrarily decided it should be. I hope that my wheels have tires on them, so you can't see through the valve hole.