Quote:
Originally Posted by Mark McM
If you do build it up with traditional 1:1 lacing, I'd suggest using differential spoking - very thin spokes on the left, and thicker spokes on the right.
|
Thanks. 2.0/1.5/2.0 left, 2.0/1.8/2.0 right?
Quote:
Originally Posted by Mark McM
By the way, the tension balance is going to be the ratio of the Sines of bracing angles of the right and left spokes. Because the angles are small, they the Sines will nearly proportional to the flange offset distances. So a good approximation of the spoke tension ratio will be the ration of the right/left flange offsets. The ratio of 17.5mm right flange offset and 42.5mm left flange offset is 0.412 (41.2%), which is what the Edd calculator reported.
|
Thank you! That was what I was looking for.