lacing 12mm thru axle @ front: are end-cap faces symmetrical?
first time lacing up a 12mm TA front wheel w/ std 100mm spacing. are the drop-out faces symmetrical with respect to the wheel/fork centerline? i'm assuming affirmative.
asking because...if everything is symmetrical i can just slide in a TA and nestle the wheel into the truing-stand cradle as if it were a QR hub... i.e., no need for special bits to get the hub end-caps centered in the truing stand.
Last edited by wallymann; 01-26-2020 at 01:58 PM.
|