View Single Post
  #1  
Old 01-23-2019, 06:24 PM
clyde the point clyde the point is offline
Senior Member
 
Join Date: Sep 2011
Location: Greenville SC
Posts: 653
Bearing removal from an Alex wheel

The bearing needs to come out in order to remove the freehub assembly from the hub. The non drive side was easy, it had a "lip" available to push from. The drive side has like a 1mm lip that is difficult to contact. I believe the drive side bearing must come out to remove the freehub body, which appears to be similar to Shimano using a big 14mm? allen key. The 14mm key does not fit through the non-drive side of the hub. These are Devox branded rims, Felt's house private label. The Alex # is BRD-50812N
Pics below, welcoming suggestions. Thanks.
[IMG]IMG_0057 by Clyde the Pointer, on Flickr[/IMG]
[IMG]IMG_0058 by Clyde the Pointer, on Flickr[/IMG]
[IMG]IMG_0059 by Clyde the Pointer, on Flickr[/IMG]
Reply With Quote