[owly]

Getting toward finalizing a design in BikeCad for kind of this thing, but defo not low trail.
Was going to do qr, but thought thru-axle would be the sensible option going forward.
Would only be putting a small Nitto rack up front, and small rear rack.

Planning to ride on road to get to the rough etc. stuff. 29x2.6 on 430 c.stay.
Fork pushing 430atc. About 53mm? offset.
Hta around 71.2deg. Trail close to 70mm. 70mm'ish stem. Dropbar.

Going to throw on a vintage French downtube shifter for the 2x front only.
Not chunky tubing.

Ideally would have a horizontal top tube, but the curved seat tube I'm using isn't long enough.