03-24-2023, 06:57 PM
|
Senior Member
|
|
Join Date: May 2010
Location: Long Island, NY
Posts: 4,572
|
|
Quote:
Originally Posted by NHAero
Tink tink tink tink
|
Quote:
Originally Posted by YesNdeed
On the seat post. Old French standards are different from just every modern standard, so I ran into many problems on this project. I bought a 26mm seat post of I don't remember origin (the clamp points to Kalloy), and cut down the insertable area by about a tenth or two/mm by hand using a heavy grit sandpaper, as evenly as possible, then re-shining it with a finer grit which only takes a few rotations.
With the saddle attached, squeezing the insertion area of the post with one hand, and rotating the post by the tip of the saddle with the other hand. Took less than 30 minutes. The seatpost collar bolts were replaced with stainless steel carriage bolts from the hardware. A cheap set of vernier calipers helped with this.
|
This reminded me that I have a metal lathe I could finally put to good use!
|