Lezyne cnc pump pressure gauge

[Erik.Lazdins]

Have used my cnc pump for the past 13 months happily then the pressure gauge plotzed.

Any sources on one?

I assume the gauge just screws in - thats how it appears.

Thanks,
Erik

[AngryScientist]

call lezyne? just checked and all lezyne pumps have a 2 year warranty, i'm sure they'll hook you up.

[gone]

+1 on calling Lezyne. Even if it's out of warranty, they'll probably still fix you up. Stand up company.

[KF9YR]

It's hard to find their number...

(805) 548-8780

[Sam in VA]

+1 on calling Lezyne. Even if it's out of warranty, they'll probably still fix you up. Stand up company.

I had the same problem about 6 months ago... turns out they had a bad lot of gauges. They sent me a new one out without charge.

[11.4]

They do have the gauges and they are actually listed on their accessory web page. But they are good at service and will simply send you one. They are surprisingly tinny and you have to tighten it in without cracking or deforming the crystal or bezel, or it leaks at the connection. Just be aware. I found an alternative in a high-quality pressure gauge with the same center-mount mounting thread; it stuck up a few millimeters but it was also built like a brick -- about $30 from MSC.

[Stan Lee]

They they are good at service


Agreed- we sell a ton of their frame pumps and a few of their floor pumps and they tend to fix any issue without question.