View Full Version : Stella Azzurra carbon bars
jischr
03-23-2011, 07:54 AM
I picked up a used bike recently that has Stella Azzurra carbon handle bars. Stella A doesn’t have an active website. Anyone have these and know what the torque requirement is for a 4 bolt stem? Is there a typical torque value around which most manufacturer’s specify?
Thanks,
John
Joachim
03-23-2011, 08:00 AM
Hi,
I used 6nM for an Edge/Enve carbon stem with Edge/Enve carbon bars (at the faceplate).
Fixed
03-23-2011, 08:16 AM
i have them on my cannondale with a look stem . i just tighten them down like any other stem bars combo good and snug no problems yet i do make sure i cross pattern when i tighten ..
cheers
ahumblecycler
03-23-2011, 08:32 AM
Is the stem also SA? I would say go with 5nm with carbon paste. If the stem is not SA, torque specifications are typically found on the stem.
pdmtong
03-23-2011, 09:58 PM
5 n-m
TimmyB
03-23-2011, 10:29 PM
4nm (with paste) would be my suggestion.
amgc36
03-26-2011, 11:19 AM
Never heard of using paste. What kind do you use?
dave thompson
03-26-2011, 11:23 AM
Never heard of using paste. What kind do you use?
http://www.cswestbikes.com/servlet/the-817/FSA-Carbon-Fiber-Assembly/Detail
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.