FSA and Campy Torx bolts

[guylimey]

Does any forumite know if the FSA Torx bolts also fit Campagnolo cranks? Thank you.

[oliver1850]

I would think they would. I believe I have some and can check.

[pitcrew]

I'm assuming you're refering to the chainring bolts? If so, which model of Campy crank?

[oliver1850]

I was assuming chainring bolts too. I replaced one in a Record 8 and a Centaur 10 with no problem. You will have to use the long Campy bolt in the 5th hole if you have a Chorus or Record with the hidden 5th bolt. No 11 speed crank here to check.

[pitcrew]

The UT cranks use a UT specific chainring bolt (smaller diameter than the "norm"). Campy and KCNC are the only makers I know of that make a chainring bolt to fit UT.

Non UT cranks should work with a "normal" sized chainring bolt.

[oliver1850]

good to know, Greg. I have a UT, but never thought to check.

[oldpotatoe]

Does any forumite know if the FSA Torx bolts also fit Campagnolo cranks? Thank you.

Nope, the FSA 6mm on the back side are too big. The holes in the crank arm are small and Campagnolo specific, for the Campagnolo CARBON cranks.

ALU Campagnolo cranks, fine and dandy but I would use steel CR bolts.