Deda zero 100 bars

[jpw]

Does anyone know what the diameter of the Deda zero 100 bar is after it stops tapering down from the 31.7mm centre bulge and before it begins turning the corner to the outside?

[rudetay]

Mine are taped up, so I'm not of much help, but I feel like I should mention that that area is slightly oval shaped with grooves on the bottom. The width is barely smaller than the 31.7 section, but the height narrows more dramatically.

I would imagine this would cause a problem clamping anything on there.

But the 31.7 section is pretty wide, roughly 12cm. So, if you are planning on mounting cross levers or the like, they will probably work best on there.