1" Ht, 1 1/8 steerer".. any headset?

[amator]

Does such a contraption headset exist? sort of like the Chris King devolution in reverse?

[TMB]

Does such a contraption headset exist? sort of like the Chris King devolution in reverse?

If the steer tube is bigger than the head tube that you plan to TRY and put the steer tube into ............................... ?????????

No, such a beast does not exist.

[dannyg1]

Nope, you're in need of a fork with a 1" steerer tube. I'm selling a Look HSC3 wth a 300mm 1" steerer, both fork/steerer are full carbon, for $125 in the classifieds. Dirt cheap for a high-end fork.

http://forums.thepaceline.net/showthread.php?t=48231&highlight=hsc3

[Grant McLean]

There is enough room for a 28.6 fork steerer to fit inside the head tube
of a 1" frame, just not enough room for headset cups.

I saw a picture from the NAHBS of a steel frame with steel chris king
headset cups brazed directly to the headtube, instead of being pressed in.
It works.

http://www.flickr.com/photos/bikeportland/2252735371/in/set-72157603871477660/

-g

[amator]

If the steer tube is bigger than the head tube that you plan to TRY and put the steer tube into ............................... ?????????

No, such a beast does not exist.

a 1 1/8 steerer is sitting in the 1 inch HT of a frame right now...Its only when i took my 1 1/8 headset that i realised that its 1 inch. Im thinking along the lines of a bigger diametr flange out etc to house the bearings.
just hopeful

[amator]

There is enough room for a 28.6 fork steerer to fit inside the head tube
of a 1" frame, just not enough room for headset cups.

I saw a picture from the NAHBS of a steel frame with steel chris king
headset cups brazed directly to the headtube, instead of being pressed in.
It works.

http://www.flickr.com/photos/bikeportland/2252735371/in/set-72157603871477660/

-g
.. mmmm thats nice

[nicrump]

will never work brazed or not. you would have about .080" per radius for headset apron and clearance.