easy one

[majorpat]

for you folks. Just built up my first campy equipped bike. Question: When using a non-grooved handlebar (Nitto Noddle) where do I route the cables? Front and back? Both together on front?
I know I'm serving up a meatball for some of you...

Pat

[stevep]

usually front low and rear low. so yr palms are sitting on the bulges
they sorta feed out that way

[72gmc]

I use Nitto bars without grooves and route the cables front and back. It's also time to replace my cables... thanks for the reminder.

[H.Frank Beshear]

I like to run both in front low on single/un grooved bars. Fits my hands better that way. Frank

[majorpat]

for all the advice, I will get 'em wrapped tonight.
Now if he sun would come back from vacation...

[Too Tall]

Pat, little trick I use to get a really nice route exiting ERGO levers is to use one or two temp. zip ties. Establish the tight bendy route out of levers blah blah blah than use strapping tape sparingly in two other spots. Once the route is done you can add one wrap of fiber tape close the ERGO and cut the temp zip tie and wrap em' :)