serpico7
09-20-2007, 04:02 PM
Building up a Fierte Ti and had a few questions about where I need anti-seize and where regular grease is sufficient.
1. Are the braze-ons for the bottle cages made of alu? If so, just regular grease, right?
2. Rear derailleur hangar - Ti or alu?
3. Seatpost clamp - Ti or alu?
4. Threaded braze-on (not sure what these are called) on the headtube into which the barrel adjuster screws in - Ti or alu?
5. Front derailleur band clamp - should I use anti-seize or grease here before mounting to seat tube?
6. Insert in the seat tube for the seatpost is alu, right? So regular grease is fine?
TIA. :)
1. Are the braze-ons for the bottle cages made of alu? If so, just regular grease, right?
2. Rear derailleur hangar - Ti or alu?
3. Seatpost clamp - Ti or alu?
4. Threaded braze-on (not sure what these are called) on the headtube into which the barrel adjuster screws in - Ti or alu?
5. Front derailleur band clamp - should I use anti-seize or grease here before mounting to seat tube?
6. Insert in the seat tube for the seatpost is alu, right? So regular grease is fine?
TIA. :)