Which models of Serotta had IT and pivots ST

[TomP]

Trying to figure out what model I have. It has the carbon titanium IT and the rear end junction of seat and chain stays has the pivot like the Ottrott and Legend ST. The down tube does not appear to be swagged. Thanks.

[SPOKE]

Be sure that you have the bearing pivots connecting the seat stays to the dropout. You could have a Fierte with that just has the stays fastened to the dropout without any bearings so it is effectively a rigid rear triangle.

[Ken Robb]

Is this model listed in any of the catalogs posted on our site?

[duff_duffy]

Can you post pic of bike and rear drop out?

[happycampyer]

Can you post pic of bike and rear drop out?
I was going to say the same thing. Post a photo of the dropout. Also, post the serial number—it will help identify the frame. Afaik, only the Ottrott (and in later years, the Ottrott SE, and not the SG) had the ST bearings.

[TomP]

Thanks for the help. Here is a photo of the drop out. I also measured the tubes with calipers. The top tube, down tube and seat tube are all swagger. The serial number is FE 54S 569

[SPOKE]

Thanks for the help. Here is a photo of the drop out. I also measured the tubes with calipers. The top tube, down tube and seat tube are all swagger. The serial number is FE 54S 569

Unfortunately the pic shows a fixed joint (not ST) found on the GS models.

[TomP]

Thank you for the help.