Campagnolo Racing T Triple 9 Speed Rear Derailleur

[Dan837]

I bent my Campagnolo Racing T triple 9 Speed Rear Derailleur. I s their anywhere to send the derailleur to be repaired? Is it very easy to find a used Campagnolo Racing T Triple 9 Speed Rear Derailleur?

Thank You
Dan837

[Hindmost]

What part is bent? If it is the pulley cage that might be disassembled and carefully straightened.

[thwart]

Someone here probably has one...

If not, eBay is your friend. I was looking for one awhile back, and it took a couple of weeks, but a nice one eventually popped up.

You could also use a mid-cage Daytona or Chorus 9-spd from the pre-mosdel year 2000 era.

The pull ratio is slightly different, but a post-2000 RD (mid cage or long cage, 9 spd or 10 spd) would likely work OK too. I think our resident Campy expert 'oldpotatoe' has said they're interchangeable.

[bicimechanic]

I have a almost new Campagnolo Racing Triple rear derailleur in stock if you are interested in replacing it.

jason@servicecoursecycle.com

[oldpotatoe]

I bent my Campagnolo Racing T triple 9 Speed Rear Derailleur. I s their anywhere to send the derailleur to be repaired? Is it very easy to find a used Campagnolo Racing T Triple 9 Speed Rear Derailleur?

Thank You
Dan837

Just use a ‘Comp’, modern Athena or Veloce. Even tho 10s or even 11s, they’ll work fine.

[Ralph]

it's just your basic med cage Campy RD. All will work. It's not the long cage.

[oliver1850]

Not sure I have a Racing Triple, but have several used medium cage RDs from the 8/9 era that might work for you. PM if interested.

[cnighbor1]

What part is bent? If it is the pulley cage that might be disassembled and carefully straightened.

Yes if cage bent take two 1 x 3'' block on wood Place either side of one bent cage and using a 'C" wood clamp tighten down till flat
should be flat again now Repeat

[Dan837]

I am interested if you have a campy 9 speed.

Dan837