phoenix
02-22-2017, 08:00 PM
I’m curious if anyone else is, or has had difficulty getting their saddles level when installing on an Enve 2-bolt post. I’m attempting to run a Specialized Romin Evo Pro saddle, as the title of the thread suggests. Call me Captain Obvious. I’m using the correct 7x10 hardware/cradles and just can’t get my saddle level. I’ve tried both orientations of the bottom cradle which leaves the nose of the saddle a bit too high, or a bit too low. I just can’t seem to get it just right. The seat tube angle on my bike is 73.5° just to throw that out there. For what it’s worth, I swapped out the post hardware to accommodate a saddle with round ti rails and was able to get it set up perfectly right away.
Has anyone had any similar set-up difficulty? Kind of stumped at this point. I’m open to suggestions and or pointers. Thanks!
Has anyone had any similar set-up difficulty? Kind of stumped at this point. I’m open to suggestions and or pointers. Thanks!