Clip on pump peg for top tube on seven

[cnighbor1]

I need a clip on or bolt on pump peg or umbrella clip for my Seven Need
1 1/4" diameter
If there even such an item for that diameter top tube
It has ST and DT water bosses so no pump there and no HT peg brazed on for locating a pump under TT
thanks
Charles

[Slow Eddie]

Is there a particular pump you want to fit in there?

I've had good luck with the Topeak Road Master Blaster fitting under top tubes (with and) without pump pegs on a whole mess of different frame geometries, materials and tube shapes. I use the little velcro strap they supply just in case, but with some fits I don't even think I need it.

Zefal probably still makes plastic hose-clampey pump pegs that go around the top tube; they've been around since steel frames reigned supreme, so I don't know if the length has been updated to accomodate fatter top tubes.

You could also fasten a zip-tie around the head tube and position the head of the zip-tie where the pump peg would go.

But man, if you're rollin' on a Seven, just find a frame-fit pump that stays in place without all that hoopty stuff. I see CF blackburns come up on the 'bay every now and again. ATMO.

[cnighbor1]

yes all that could work but would like to use my old Silca pumps which I have a few
the obvious answer is a mini pump which come with a clip on device that bolt to bottle cage holes Just trying to use what I have on hand
I think about your solutions
Is there a particular pump you want to fit in there?

I've had good luck with the Topeak Road Master Blaster fitting under top tubes (with and) without pump pegs on a whole mess of different frame geometries, materials and tube shapes. I use the little velcro strap they supply just in case, but with some fits I don't even think I need it.

Zefal probably still makes plastic hose-clampey pump pegs that go around the top tube; they've been around since steel frames reigned supreme, so I don't know if the length has been updated to accomodate fatter top tubes.

You could also fasten a zip-tie around the head tube and position the head of the zip-tie where the pump peg would go.

But man, if you're rollin' on a Seven, just find a frame-fit pump that stays in place without all that hoopty stuff. I see CF blackburns come up on the 'bay every now and again. ATMO.

[drewellison]

Charles,
Here's a similar topic thread you might find helpful.
Drew

http://forums.thepaceline.net/showthread.php?t=186860

[jc031699]

http://www.zefal.com/en/pumps/260-pump-pegs-xl-.html

http://www.zefal.com/en/pumps/261-pump-pegs-xxl-.html