DT Swiss 350 rear - spaced 135?

[henrypretz]

I purchased a never built up DT 350/non disc/Shim10 spd hub assuming it would be 130 spacing. It measures out slightly over 135.
Any input on what this is? Guidance on respacing it to 130? If I get the 11 spd freehub won't it still be spaced at 135? Any ideas or advice will be appreciated.

Thx
Henry

[David Kirk]

DT hubs use different end caps to set the hub width. You'd need the proper end caps and then to check the dish to be sure it's cool with where you end up.

You local dealer can get the DT caps through QBP and maybe you can get them online.

dave

[oldpotatoe]

I purchased a never built up DT 350/non disc/Shim10 spd hub assuming it would be 130 spacing. It measures out slightly over 135.
Any input on what this is? Guidance on respacing it to 130? If I get the 11 spd freehub won't it still be spaced at 135? Any ideas or advice will be appreciated.

Thx
Henry

What David said. You have a 'MTB' DT 350, non disc, hub. 2 end caps(I have them, BTW-$35 shipped), will make it 130mm.

Just got an email from the Tech guys at DT GrandJunction and all you need is the '130mm' LH axle end. I still have the axle ends(RH being the same).

[henrypretz]

Thank you Dave and Peter. When I bought the hub I never asked and the seller never said what the spacing was. I appreciate your replies.

Henry

[Dead Man]

Thank you Dave and Peter. When I bought the hub I never asked and the seller never said what the spacing was. I appreciate your replies.

Henry

Hmm.. that fact wasn't mentioned to me, either - I also purchased it from a forumite.

Want a refund?

EDIT - actually, he (the bro I bought it from) had spacing listed in the original thread... so definitely my bad