Campy over torque bb installation

[tuscanyswe]

I forgot to put on the plastic sleeve in between the cups before inside the bb shell before i pressed the (loctited) cups into the frame.

Anyone know if these have any real function or if i can make do as it is? Have read enough about these things creaking even installed properly..
Hoping its like with hollowtech II bb sleeves that you don't really need them?

I was getting more n more stressed with the slow installation watching the loctite dry lol This middle part is what i forgot:crap:


http://road.cc/sites/default/files/cropped/node-gallery-display/images/Campag%20Over-Torque/PFBB386-86,5X46cerUSB-2014.jpg

[oldpotatoe]

I forgot to put on the plastic sleeve in between the cups before inside the bb shell before i pressed the (loctited) cups into the frame.

Anyone know if these have any real function or if i can make do as it is? Have read enough about these things creaking even installed properly..
Hoping its like with hollowtech II bb sleeves that you don't really need them?

I was getting more n more stressed with the slow installation watching the loctite dry lol This middle part is what i forgot:crap:


http://road.cc/sites/default/files/cropped/node-gallery-display/images/Campag%20Over-Torque/PFBB386-86,5X46cerUSB-2014.jpg

This one there for EPS wires that are run over BB..no other function. Hollowtech same but really a crud guard also. These not.

[tuscanyswe]

This one there for EPS wires that are run over BB..no other function. Hollowtech same but really a crud guard also. These not.

Thanks, didn't look rigid enough to be a stabilizing function. But this build have been very slow allrdy so i wouldn't have been surprised if it turned out it was essential for the integrity of the bb either with my current luck :)

Thanks a bunch, guess i saved me some weight..

Cheers
Björn