MaraudingWalrus
01-03-2016, 07:47 PM
I have in mind a project for a bike with drop bars, and an IGH, an Alfine (or possibly a SRAM G9). It seems that the only options for doing this is, dremel-ing out a trigger shifter to fit onto the drops, finding an old Versa Alfine shifter, or the JTek bar end. QBP also has a Microshift bar end for Alfine that's set to show up in a month or so - but if I were going bar-end I'd go JTek.
Anybody here have experience using any of these set-ups?
Not thinking I'm too stoked on the dremel-ing options.
Anybody actually used the JTeks?
I thought I saw somewhere that Microshift obtained Versa shifter, but I can't find that anywhere. Nor have I found the Versa shifters for sale anywhere.
Is there a drop-bar rig for the G9 hub?
Planning a Cannondale Hooligan drop bar build for kicks and giggles - Di2 alfine is the obvious answer, but is a good bit more expensive than I'd like to do.
Anybody here have experience using any of these set-ups?
Not thinking I'm too stoked on the dremel-ing options.
Anybody actually used the JTeks?
I thought I saw somewhere that Microshift obtained Versa shifter, but I can't find that anywhere. Nor have I found the Versa shifters for sale anywhere.
Is there a drop-bar rig for the G9 hub?
Planning a Cannondale Hooligan drop bar build for kicks and giggles - Di2 alfine is the obvious answer, but is a good bit more expensive than I'd like to do.