View Full Version : Adjusting the HB-PR019 adjusting sleeve
Veloo
09-13-2014, 07:24 AM
How tight should I go when threading on the HB-PR019 adjusting sleeve on Campy hubs? This is the clamping ring with the little allen bolt.
Do you guys thread on just until it makes contact? Should I go a bit tighter than just initial contact? Back it off at all?
oldpotatoe
09-13-2014, 07:52 AM
How tight should I go when threading on the HB-PR019 adjusting sleeve on Campy hubs? This is the clamping ring with the little allen bolt.
Do you guys thread on just until it makes contact? Should I go a bit tighter than just initial contact? Back it off at all?
Put wheel in frame/fork...tighten plate down, wiggle wheel to see if there is play..rotate plate just until play is gone..tighten allen screw.
Veloo
09-13-2014, 08:52 AM
thanks again OP.
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.