COskibum
01-11-2012, 04:00 PM
Hey guys, new poster here. My wife has a Fierte Ti with the carbon seat stay, and a Ti chain stay. They are held together (by the rear derailleur) with a single T50 Torx bolt.
My wife (after putting on ~ 3,500 miles in 12 months) recently had "the creak". I started by checking bolt tightness, and found this T50 was fairly loose. What is the proper spec for tightening this bolt? i.e. 50ft*lbs, 75ft*lbs?
If this doesn't fix it, then we get to ti-prep all the clamps/ fittings.
My wife (after putting on ~ 3,500 miles in 12 months) recently had "the creak". I started by checking bolt tightness, and found this T50 was fairly loose. What is the proper spec for tightening this bolt? i.e. 50ft*lbs, 75ft*lbs?
If this doesn't fix it, then we get to ti-prep all the clamps/ fittings.