#1
|
|||
|
|||
Dremel?
noticed Dremel was recommended for cutting cable housing
anyone have recommendations on model and accessories? |
#2
|
|||
|
|||
doesn't matter the model. but a cordless is easier. the reinforced cutting wheels are best. last the longest too.
I use Shimano TL-CT10 cutters and a bench grinder to smooth them down. Sadly they don't make them anymore. They are the best. |
#3
|
|||
|
|||
Quote:
Anyway, yes the reinforced wheels do last longer for dremel, just don't heat up and melt the liner. I prefer a decent sharp file to getting out and setting up a dremel. The best was having a small bench mounted belt sander to dress the ends, that thing had so many great uses, but I don't have room for one in my garage. |
#4
|
|||
|
|||
Quote:
|
#5
|
|||
|
|||
Those are the ones I am referring to as well. I didn't care for them, but I know others did.
|
#6
|
|||
|
|||
You are literally the first person who's ever said that to me. Usually it's them saying they miss them or wish they could buy them again.
|
#7
|
||||
|
||||
I’ve got a pair of the blue and grey shimano cutters sitting in my tool box but always reach for my felcos when i need to cut cables.
__________________
Carping all them diems |
#8
|
|||
|
|||
Oh cutters... I have I think a pair of pedros or is ice toolz? :/ and they worked ok, the problem is that you have to snap super quick to get a clean cut.
Dremel works but is not the same. Love the dremel tool but is not good IMO for bike cable cutting. Last edited by ultraman6970; 10-18-2017 at 12:30 AM. |
#9
|
||||
|
||||
Any Dremel(cordless is nice but gotta charge) and this wheel.
__________________
Chisholm's Custom Wheels Qui Si Parla Campagnolo |
#10
|
|||
|
|||
thanks for the advice
will go cordless as outlets in my garage are not very conveniently located wanting it more for a multi-tool and to file down sharp edges |
#11
|
||||
|
||||
using quality cutters (for me, the Park Tool version) and a dremel to clean it all up, i discovered a true ah ha! moment in bike maintenance: suddenly my shifts were crisp, my rear brake no longer mushy. I use an older plug-in dremel, and a little sanding barrel rather than a disk, with a small bench vise to hold the housing.
|
#12
|
||||
|
||||
If you already have a Dremel or you foresee using one in the future then fine but, a dedicated cutter is the way to go imho. A bench grinder is real nice too but you can use a file as well.
|
#13
|
|||
|
|||
I have a dremel, and I've never done it this way. maybe I should try. My Pedros cutter works fine for me, and i don't think I will wear it out.
Have thought about getting a Knipex though. |
#14
|
|||
|
|||
My preference are these SunTours. I purchased them in the mid-80's. Second best are the blu/grey Shimano.
|
#15
|
|||
|
|||
I have an ancient pair of Nashbar cutters that work way better than my newer Park cutters.
|
|
|