|
|
|
|
#1
01-10-2021, 04:52 PM
|
||||
|
||||
|
Tacx Galaxia bearing replaceable?
Few of the bearings on my Galaxia rollers seem a bit gritty.
The stamp on it seems to read "5200Z C3". Anyone know if these are replaceable? They don't look easily removed. Here's a fuzzy photo. 
|
|
#2
01-10-2021, 05:35 PM
|
|||
|
|||
|
5200 bearings are a standard 10mm x 30mm x 14.3mm industrial bearing (the Z means dust shields, and the C3 is for standard radial clearances). Your bearings are very likely replaceable - if you have the right tools to knock out the old bearings and press in the new ones.
|
|
#3
01-10-2021, 06:20 PM
|
|||
|
|||
|
You could also punch out the press fit dust shields with an awl and then clean them out, but that is a one-way move(the shields will be destroyed and you won't be able to use them to keep out dirt anymore).
|
|
#4
01-23-2021, 01:26 PM
|
||||
|
||||
|
I read the stamping wrong. It's actually 6200Z C3.
Local bearing shops are quoting around $10 each. I've seen other Galaxia rollers using bearings with rubber side shields. Hoping I can find cheaper replacements. Any bearing aficionados have recommendations for a different spec?
|
|
#5
01-23-2021, 02:21 PM
|
||||
|
||||
|
Hey Danny,
Will 6200 2RS 10x30x9 Bearings work ? At Bearings Canada for $16.84 cdn for 10 bearings. https://www.bearingscanada.com/10-Be...-10mm-bore.htm Or Amazon.ca for cheap at 9.00 for 10 https://www.amazon.ca/6200-2RS-Beari...1433081&sr=8-1
__________________
Brian North of the 49th Parallel
|
 |
|
|
Linear Mode
