Know the rules The Paceline Forum Builder's Spotlight


Go Back   The Paceline Forum > General Discussion

Reply
 
Thread Tools Display Modes
  #1  
Old 12-29-2016, 12:13 AM
comish83 comish83 is offline
Member
 
Join Date: May 2015
Posts: 63
Chain Cleaner Tool

I was wondering if either of the two chain cleaner tools come recommended by anyone? GCN has a video recommending the Muc-Off X-3 which is $45 but I am curious if anyone has tried the $10 Fyong chain cleaning tool?

Muc-off X-3 $45
https://www.amazon.com/Muc-Off-277-C...+chain+cleaner

Amazon also has a cheap $10 Fyoung Bike Cleaner.
https://www.amazon.com/dp/B01MFB1640...P01-V01-O3-B55
Reply With Quote
  #2  
Old 12-29-2016, 12:25 AM
ultraman6970 ultraman6970 is offline
Senior Member
 
Join Date: Nov 2010
Posts: 22,852
Never used one of those because I always be under the impression that at the end the brushes inside of the devices end up so nasty that need to clean them afterwards.

Is faster and quicker just use the rag/paper towel and oil technique.
Reply With Quote
  #3  
Old 12-29-2016, 12:30 AM
Llewellyn's Avatar
Llewellyn Llewellyn is offline
Senior Member
 
Join Date: Aug 2012
Location: Perth, Australia
Posts: 1,592
Get an old paintbrush and the degreaser of your choice and smother the chain thoroughly. Let the gunk drip off and then wash. Cheaper than both of the options you listed (and much more effective too).
Reply With Quote
  #4  
Old 12-29-2016, 02:05 AM
dgauthier dgauthier is offline
Senior Member
 
Join Date: Dec 2003
Location: Los Angeles, CA
Posts: 1,402
For $45 they can definitely muc-off...

+1 for a rag.

Last edited by dgauthier; 12-29-2016 at 02:07 AM.
Reply With Quote
  #5  
Old 12-29-2016, 04:58 AM
KonaSS KonaSS is offline
Senior Member
 
Join Date: Jul 2007
Posts: 1,950
These type of cleaners can work well. I would go with the cheapo one. This isn't rocket science.
Reply With Quote
  #6  
Old 12-29-2016, 05:23 AM
oldpotatoe's Avatar
oldpotatoe oldpotatoe is offline
Proud Grandpa
 
Join Date: Oct 2009
Location: Republic of Boulder, USA
Posts: 47,055
Quote:
Originally Posted by comish83 View Post
I was wondering if either of the two chain cleaner tools come recommended by anyone? GCN has a video recommending the Muc-Off X-3 which is $45 but I am curious if anyone has tried the $10 Fyong chain cleaning tool?

Muc-off X-3 $45
https://www.amazon.com/Muc-Off-277-C...+chain+cleaner

Amazon also has a cheap $10 Fyoung Bike Cleaner.
https://www.amazon.com/dp/B01MFB1640...P01-V01-O3-B55
Buy some snap links, get a cleaned plastic milk bottle..some mineral spirits..chain off, shake, shake, shake, let dry, put back on.

I 'clean' my chain about once a month if I'm riding 4-5 days a week. I lube it when it sounds like I have a bird in my pocket..after that ride.
__________________
Chisholm's Custom Wheels
Qui Si Parla Campagnolo

Last edited by oldpotatoe; 12-29-2016 at 05:37 AM.
Reply With Quote
  #7  
Old 12-29-2016, 05:26 AM
martl's Avatar
martl martl is offline
Strong Walker
 
Join Date: Apr 2008
Posts: 2,057
Those who clean their chains a lot (especially with degreaser), end up buying lots of chains. I'm with Jobst Brandt on that one. Wipe outside clean with an oily rag, apply oil very carefully to the links, wipe excess off again.
__________________
Jeremy Clarksons bike-riding cousin

Last edited by martl; 12-29-2016 at 06:04 AM.
Reply With Quote
  #8  
Old 12-29-2016, 06:56 AM
regularguy412's Avatar
regularguy412 regularguy412 is offline
Veni Veloce Vomiti
 
Join Date: Feb 2007
Location: Kudos to Ahneida for a twist on his 'title'
Posts: 2,738
I've had REALLY good luck with just good ol' WD-40 as the 'cleaner' (solvent). Wipe down really well and let it air-cure for a few minutes. Then follow up with some home-brew lube (3:1 ratio with camp fuel as the 3 and synthetic motor oil as the 1).I use a 1:3 ratio of the same stuff to lube other pivot points.

I just measured my chain that I've been using for 2 years ( ~6,000 miles) on my Fondo (7900 DA steel chainrings) and there is still NO appreciable stretch. I measured it at a couple of different points with same result.

I'm actually amazed at the lack of wear. I've worn out many, many chains in 30 years and this is the best result I've ever had.

I used to use one of those chain cleaners (Vetta). Found that it didn't really do much good and did, as others have posted, gunk up inside and needed, itself, to be cleaned frequently.

Mike in AR
__________________
2013 Serotta Fondo Ti w/Enve fork
Reply With Quote
  #9  
Old 12-29-2016, 07:02 AM
Cicli Cicli is offline
Lanterne rouge
 
Join Date: Apr 2014
Location: Oro Valley Az.
Posts: 7,194
Those chain cleaners are a joke. OMS and a jar works well. OMS and a rag works really well too.
For a data point, I cleaned a cassette with simple green yesterday. It will be the first and last time I use simple green on a bike. Too slow and too much scrubing. OMS is better and works much better as a solvent. I would never use a water based cleaner on a chain either.
WD 40 works well as a solvent for cleaning.
Reply With Quote
  #10  
Old 12-29-2016, 07:18 AM
ultraman6970 ultraman6970 is offline
Senior Member
 
Join Date: Nov 2010
Posts: 22,852
What is OMS?
Reply With Quote
  #11  
Old 12-29-2016, 07:31 AM
rwsaunders's Avatar
rwsaunders rwsaunders is offline
Everything is connected
 
Join Date: Nov 2005
Location: Seaburgh
Posts: 11,210
Quote:
Originally Posted by ultraman6970 View Post
What is OMS?
Odorless mineral spirits.
Reply With Quote
  #12  
Old 12-29-2016, 07:32 AM
ColonelJLloyd ColonelJLloyd is offline
Senior Member
 
Join Date: Dec 2012
Location: Louisville
Posts: 5,831
I'm with Old Potatoe. Remove the damn chain from the bike, people. Use a jar, jug, ultrasonic cleaner or whatever works for you. If you want to clean the chain well, you need to remove it. I echo the "no water based anything", which seems very common sense to me.
Reply With Quote
  #13  
Old 12-29-2016, 07:32 AM
ultraman6970 ultraman6970 is offline
Senior Member
 
Join Date: Nov 2010
Posts: 22,852
Thanks
Reply With Quote
  #14  
Old 12-29-2016, 07:46 AM
Jgrooms's Avatar
Jgrooms Jgrooms is offline
Senior Member
 
Join Date: Jul 2013
Location: Shawnee Kansas
Posts: 1,005
Chain Cleaner Tool





Drop wheel & install my chain cleaning hub.

Fill cleaner, attach & spin. Done. Works. Period.

Remove chain? One time replaceable link- unnecessary hassle imo.

Rag & solvent. Good quickie clean with WD-40. However, that isn't getting down between rollers & pins.

Last edited by Jgrooms; 12-29-2016 at 07:59 AM.
Reply With Quote
  #15  
Old 12-29-2016, 07:56 AM
Tony T's Avatar
Tony T Tony T is offline
Senior Member
 
Join Date: Feb 2012
Posts: 6,158
I use the Park chain cleaner and Pedro's Oranj Peelz
(Muc-off looks like a Park knock-off)

Park brushes are removable from the tool for easy cleaning.
Reply With Quote
Reply

Tags
chain


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:52 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.