Rims rims rims

[oldpotatoe]

Originally Posted by iPaul

With the front wheel done, it looks like I now need to reach out for a bit of help as I now have a question in regards to lacing my rear wheel straight pull GS hub.

Starting form the drive side when lacing, is it best to run the first set of spokes from the inside hub holes or the outside holes located on the flange? Thanks

Doesn't matter..24h, and 2 cross..first cross at hub, then if inside, under over..if the outboard hub holes, over then under. I probably do the inside ones first, then lace the outboard.

[DRZRM]

I was using HED Belgium on several bikes and liked them. I've now build 3 wheelsets with V2 Pacenti SL23 and love them. Easy build, set up tubeless, not too hard to get tires on in the shop or the field. The new offset rims look nice too.

[Tony T]

Originally Posted by iPaul

Thank you. I agree holes look offset on tire side but run center on rim side. Would that mean they are angled and I should run spokes as you mentioned, left offset tire side to right side of hub?

Yes.
I was also confused with this on my Archetypes. Put in one spoke and screw in a nipple and you will see the direction that spoke takes.
Musson covers this in his book:

See also: http://forums.thepaceline.net/showthread.php?t=196499

[iPaul]

Thanks all for the help. I think I'm on the right track now. Just a small stumble but all are now laced and on to part two.

[Fatty]

DT Swiss RR511. Like $50 a pop at StarBike.com .