#1
|
|||
|
|||
Reynolds freehub - replacing Shimano with Campy
Have a bike with Ultegra 10 currently, that I would like to replace with 10sp Record which I have in hand. Wheels are Reynolds Solitude with Reynolds 10 sp freehub body for Shimano. Unfortunately, I don't think it is a DT Swiss freehub, which would I believe make for a simple swap. I think they are what Reynolds calls KT freehub. Wheels are practically new, so it would be nice to keep them for the moment, particularly since don't want to invest $$$ on this bike presently. Any ideas on what freehub would work? Thanks
Last edited by galgal; 04-20-2017 at 08:41 PM. |
#2
|
||||
|
||||
Call Reynolds. I converted some older hubs from Campy to Shimano a few years ago, hubs circa 2005. They helped figure out what I had, what would work.
|
#3
|
|||
|
|||
Quote:
Reynolds offers both Campagnolo and Shimano replacement freehub bodies. They are available on their webshop. |
#4
|
||||
|
||||
I have an older Reynolds freehub that is not convertible. you are pretty much stuck with Shimano cassettes. But there is a solution! http://www.jtekengineering.com/shiftmate/
go to resources and find a dealer, mine works fine. These are not cheap, but the good news is that Shimano cassettes are available in a wider range and they're cheaper than Campy. |
#5
|
||||
|
||||
Quote:
__________________
Chisholm's Custom Wheels Qui Si Parla Campagnolo |
#6
|
|||
|
|||
Thanks for suggestions. I don't believe Reynolds offers a 10sp Campy freehub anymore but will double check. Ditto for Accelerator cogset, 10sp version discontinued. Might have to resort to Jtek option.
|
#7
|
||||
|
||||
the cogset from wheels manufacturing is not cheap if you can find it. then its a cogset, which means it will wear out, then the hunt begins again. the Jtek really doesn't wear out and you could go through many cogsets as you ride along!
|
#8
|
|||
|
|||
Quote:
The Ultegra works flawlessly, tbh. But I replaced Record 10 with 11 on another bike, and so want to have that replace the Ultegra. No complaints on the Shimano, guess I'm just more accustomed to Campy. And no, not trying here to debate/compare, god forbid. 😉 |
#9
|
||||
|
||||
I'm running the Jtek with a Shimano 10 speed cassette with a Campy Record shifters and it works fine. It was set up with Campy 9 speed with a Shimano 9 speed cassette on a cross bike. but once you go 11 speed, its all good, just mix and match.
|
#10
|
||||
|
||||
I switched KT freehubs on Assaults. Easy as pie. Now I run C10 but will eventually use these wheels for C11.
__________________
©2004 The Elefantino Corp. All rights reserved. |
#11
|
||||
|
||||
the newer hubs are designed for the cassette to pop in and out.
|
|
|