|
|
|
|
#1
10-21-2016, 01:00 AM
|
||||
|
||||
|
Quark... How the fap do I get it off? And more!
The internets sayeth there's a 8mm hex slot inside the 10mm, but I can slide a 10mm all the way through. Ain't no 8mm bolt in there.
Sip wit dis?    Thanks -B
__________________
where are we going, and why am i in this handbasket? Last edited by Dead Man; 10-21-2016 at 03:33 PM. 
|
|
#2
10-21-2016, 02:46 AM
|
||||
|
||||
|
What bb interface is that? Looks like you need to remove the drive side from the spindle.
Sent from my SM-G930V using Tapatalk
|
|
#5
10-21-2016, 01:27 PM
|
||||
|
||||
|
Drive side extraction.. Weird. Got it off... Thanks gents.
Btw - how do you tell which model it is? Some numbers here and there, but no model name that I can find
__________________
where are we going, and why am i in this handbasket?
|
|
#6
10-21-2016, 03:34 PM
|
||||
|
||||
|
And another question... the big fat spacer on the drive side... should that stay with this crankset, or do I need to save that to plug on the new crankset that's going on this bike?
Are the BB30 spindle lengths all the same? Are the shell widths all the same on these pressfit BB30 shell frames? Thanks again gents -B
__________________
where are we going, and why am i in this handbasket?
|
|
#8
10-21-2016, 05:07 PM
|
|||
|
|||
|
Quote:
|
|
#9
10-21-2016, 05:20 PM
|
|||
|
|||
|
That's a Cinqo Saturn spider...S900 crank arms. Or S975?
There are...4 widths of BB shell that use 30mm spindles... BB30/PF30 are 68mm wide, BB30a is...5mm wider on the drive side? BBRight is even wider on the drive side, and BB386 Evo is 86mm wide. Not all 30mm spindled cranks are the same width...some only work with the 68mm wide shells. The one on your crank will work with any of them. The spacers should stay with the crank.
|
 |
|
|
Linear Mode
