Quote:
Originally Posted by bigbill
I had an old 11 crankset in the garage that needed new bearings so I popped off the old one on the NDS. This is what I'm talking about, the spindle is tapered, and I once overtraveled a new bearing and it bound.
|
I think you'll find that the diameter is constant where the bearing is seated and the taper is only in the transition between the spindle and the bearing seat. The bearing is intended to rest against the shoulder at the bottom of the seat. If the bearing bound when fully pressed on, then there may have been something caught in the space between the bearing and the crankarm. It would be a poor design to hold a bearing that is subject to thrust forces in a fixed location on a shaft merely by friction.