ti refurbishment
So i have a older ti frame with marks where old decals were light scractches etc , what can i used to rub them out emory cloth ,very fine sand paper ?
|
try
scotch pad 1st
You might have to do whole frame to get an even look which means new decals |
green scotchbrite. Make sure you always move the pad in the direction that you want to see the grain/polish marks.
|
the OP does not say
how the bike was finished originally. If it was mirror and he takes a pad to it, he may end up with a mess.
|
ti refurbishment
its a ti colorado
|
I found a worn green scotchbrite pad works best for the finish on my Concours. I've found a fresh pad to be too aggresive.
|
I did this with a brushed Litespeed and it looks better than new. Use the Scotchbrite and follow the direction of the grain (around the tube, not long-ways) but the best tip is to no put your fingers behind where you are brushing it is too much pressure and uneven. Take a short strip of the Scotchbrite, grab each side then work it back and forth like you would shine a shoe. Don't use a lot of pressure and don't rush. It works great... If the frame is a brushed finish already that is.
|
If you want to get crazy.. a commercial wheel polish (Maguiars/Eagle 1) takes it to the next level with minimal effort
|
grey scotchbrite...
that's what james uses at black sheep...it is a pretty fine grade
if there is a lot of work, you might start with the maroon then finish with the grey cut into 1 inch strips and polish away! i ordered a box of 20...i will never use them all... PM me and i'll mail a couple to you |
Rolite Metal Polish also works well if you have a brushed finish. Don't use it or scotchbrite of you have a glossy finish.
|
.
|
Quote:
JB |
Quote:
|
Maroon-colored ScotchBrite (fine or extra fine?) is what most frame mfg's use for brushed Ti. +1 on scrubbing around the circumference of the tube.
|
pictures?
|
All times are GMT -5. The time now is 12:33 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.