Yet another titanium finish question
http://forums.roadbikereview.com/bik...ti-241064.html
Reply #12 in this thread seems to be from a Lynskey employee and discusses using 2" x 10" 7440 Scotch Brite strips to create a brushed finish. Could that be applied to a polished Legend finish to convert it to brushed? The reason would be that the brushed finish would show imperfections less than polished. Thanks. |
Found reference that Seven uses #7447, maroon colored Scotchbrite.
|
It appears that Scotchbrite is not recommended for polished finishes.
|
+1 on the maroon Scotchbrite - Seven sent me some for buffing out small scratches on my Axiom. It works great as long as you dont overdo it
|
Depends how much you trust your hand in keeping a consistent finish.
|
+1
|
Quote:
|
Maroon here too. It made my old Colorado Ti look like new. It's an easy job.
I don't see why a polished finish couldn't be converted to brushed using Scotch Brite. It's all bare metal after all with no protective clear coat over it. |
Quote:
Cut strips about 1 inch wide or less and brush like shoes. Try on a chainstay first to get an idea of the force and speed needed and you'll get it in 2 minutes. |
i've found that keeping the scotchbrite wet during the brushing process improves results.
|
All times are GMT -5. The time now is 02:33 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.